FD422S-LA-000
- Input Voltage Range From 176-253VAC
- Rated Current is (RMS) 4A
- 200-750 Watt Power Range
- Position, Speed. and Torque Control
- RS232 & RS485 (LA) or RS232 & CAN BUS (AA/CA)
- Communication Protocol: MODBUS
- Requires 2500PPR Encoder Input
- Communication Software
- Configure Parameters
- I/O Signal Monitoring
- Speed and Position Curves
- Gain Adjustments
- Programmable Inputs and Outputs
- 7 Inputs / 4 Outputs
- 2 Analog Inputs
- CAN BUS Port and CANopen Optional
- CE Certified
Description
| Technical Specifications | ||
| Model Parameter | FD422-LA-000 Series | |
| Power | Main Supply Voltage | Single-Phase AC 220V -20/+15% 47~63Hz |
| Control Circuit Voltage | 18VDC~30VDC 1A | |
| Current | Rated Current (RMS) | 4A |
| Peak Current (PEAK) | 15A | |
| Feedback Signal | 2500PPR (Incremental Encoder with 5V Supply) | |
| Brake Chopper | Use an External Braking Resistor According to Application, Mainly in Occasion of Quick Stop. |
|
| Brake Chopper Threshold | DC380V ± 5V | |
| Over-Voltage Alarming Threshold | DC400V ± 5V | |
| Under-Voltage Alarming Threshold | DC200V ± 5V | |
| Cooling Method | Natural Air Cooling | |
| Weight | 1.2 Kg | |
| Digital Input | Input Specification | 7 Digital Inputs, with COM1 Terminal for PNP (High Level Valid 12.5- 30V) or NPN (Low Level Valid) connection. |
| Input Function | Define Freely According to Requirement, Supporting Following Functions: Driver Enable, Driver Fault Reset, Driver Mode Control, Proportional Control, Positive Limit, Negative Limit, Homing Signal, Reverse Command, Internal Speed Section Control, Internal Positive Section Control, Quick Stop, Start Homing, Active Command, Switch Electronic Gear Ratio, Switch Gain. |
|
| Digital Output | Output Specification | 5 Digital outputs, OUT1~OUT4 Current is 100mA, BR+/BR- (Brake Control Output) Current is 500mA, Can Drive Brake Device Directly. |
| Output Function | Define Freely According to Requirement, Supporting Following Functions: Driver Ready, Driver Fault, Positon Reached, Motor at Zero Speed, Motor Brake, Motor Speed Reached, Z Signal, Maximum Speed Obtained in Torque Mode, Motor Brake, Position Limiting, Reference Found, Multi-Position Reached |
|
| Analog Input | 2 Analog input, can be used to control speed and Torque, the input range is -10V~10V |
|
| Encoder Signal Output | Output the Encoder Signal of Motor, Used in Multiple Axis Synchronous Control, Supports 2MHz at Most |
|
| RS232 | The Max. Baudrate os 115.2KHz, Use JD-PC Software to communicate with PC, or Via Free Protocol to communicate with Controller. |
|
| Protection Functions | Over-Voltage Protection, Under-Voltage Protection, Motor Over-Heat Protection (I²T), Short-Circuit Protection, Drive Over-Heat Protection, Etc. |
|
| RS485 | The max. baudrate is 115.2 KHz, use Modbus RTU protocol to communicate with controller. |
|
| CAN BUS | The max baudrate is 1 MHz, Communicates with Controller via CANopen Protocol |
|